Garment Care

Teamwear Care

Garments are made using high quality materials under strict quality control conditions. It should be noted that most fabrics discolour due to staining by substances such as mud and grass which may not be entirely removed by washing. Always adhere to garment care labels and follow as appropriate to minimise any chance of colour loss. We recommend removing as much mud from the garment as possible before soaking/washing. After use, soak in warm water with an appropriate (non chlorine bleach based) detergent for approximately 2 hours prior to machine washing. This process aids in the removal of stains and reduces the chance of colour loss. Pale kits such as White, Yellow, Sky and Tangerine may require more attention and the use of prewash soakers will assist in the removal of stains. Do not overfill the washing machine with garments since if the ratio of water to garments is too small, dirt can easily be re-deposited (this can stain all the garments grey). We do not recommend fabric conditioners on jerseys and shorts which may cause a build up of film on fibres. This can prevent the washing process from penetrating filaments and dislodging dirt. However, socks will benefit from fabric conditioners and softeners. Teamwear manufacturers will not accept liability for discolouration or damage to garments which is attributable to staining caused by elements foreign to the materials used in manufacture.

Transfer & Badge Care

Please adhere to the following guildlines for the majority of personalised teamwear (jerseys, polo's, etc):

- Turn garment inside out.
- Washable upto 40 degrees
- Do not use bleaching agents, biological wash powders or spot removers
- Do not tumble dry
- Do not scrub print.
- Do not iron directly onto the print.

For Nylon garments (rain jackets, etc), please adhere to the following washing instructions:

- Turn garment inside out.
- Washable upto 30 degrees
- Do not use bleaching agents, biological wash powders or spot removers
- Do not tumble dry
- Do not scrub print.
- Do not iron directly onto the print.

Should you have a question or require any further assistance, please do not hesitate to contact us.